can the software handle using PWM Servos? instead of using a Relay Valve... this way you get the full opening of the valve and not like relay the holes are smaller.. does the software handle this?
so this way I can use a Ball cock valve and a servo to turn the valve
ah ok ya so the pwm is same as a DC motor really jus a motor to open the vavle… does your software support DC motors then? if not will you add it somethime as I wanted to add a Servo open 1/2" 3/4" 1" valve and maybe 2" valve in future.
as I finding these relay water valves they either fail a lot or leak a lot.. so I wanted to use the ballcock valve with a motor and ur software to open
No, the SW can't support PWM.
Anyway there are already valves with motors, they use DC motors. Their application is for large irrigation flow volumes.