Even if I test all the boards before I package them, especially the analog part, we cannot exclude a problem with the board.

I'll send you a private message.

I checked it out. It was correct. I moved it to 04. Did a senor data and it still read 00.00.

Hi, the connection doesn't seem right. Even if the connection is very blurry 😂, the GND shoul be on the 5th pin from the left, so all the connectors should be shifted by one. Suggest to use the AN4 for the testing, should be easier to connect. After the setting reboot the system.

Good Day,

Here is a pix of my brd. No out put, I did as you said(5v to an3) and nothing.When I go to cal it reads zero. I believe everything else is working. Thanks in advance for any help.

Skip

Hi There,

All these sensors are already included in the pre-set "AutomationHAT-v10", so it would be only needed to go to the HArdwaresetting page, IN the section "Select and Load preset HW config" select the "AutomationHAT-v10" and click the button "apply selected hardwware setting". Ensure that after you click the button, the green bar indicating successful operation appears.

In case you have already done all the above, we can try to connect the AM2302 to a different PIN.

For the sensor AM3202 the Board is only exposing the PIN in a more friendly way for the connection to the sensor. You can see that the PIN is the GPIO24.

If you go to the HardwareSetting table, you will see that the two rows relevant to temperature and humidity have the PIN field to "24" (GPIO)

You can try to change the two fields with another pin, for example the 14. (if not already used).

Regarding the Analog capacitive sensors (v 1.2), they should be connected to the analog inputs on the board, (AN0 to AN4). These are already active in the setting selected above. You can try if they works by putting a Jumper connection between AN0 and 5V for example, keep it for one day and see in the graph if the reading is stable at 5.

Let me know if you are making some progress.

Thanks,

Angelo

Good Day,

I am using Captive Soil Moisture Sensor V1.2. and the Temp and Humd sensor is a SMAKN DHT22 / AM2302 Digital Temperature and Humidity Measure Sensor. The Hardware setting is Automation Hat-V10. Using a 4 relay board and one senor. Would like to use 2 servo for cam too. As I said before, the Temp and Humid senor worked without the Hat. Now that will not work. Cam is working very well. Maybe the Rpi is not working correctly. It has been around for awhile. I ordered a new one. Any help or trouble shoot info would be great. This a great project.

Thanks in advance..

Skip

Hi There, You should configure your system to support the sensor. Can you tell which sensor you have? And what config you selected in the hardwaresetting page? The more info you provide the better I can support you! Thanks

I fixed the bad gateway by downloading the latest image. But I still cant get any readings, with or without the Hat, rev 10.4. Have tried 3 different moisture senors,and a Temp/humid senor. I have ordered a new Raspberry pi Zero w .

The only thing that works is the camera. Any help would be great

Thanks