Hello,
When I try to read the value of my BH1750 light sensor via the I2C connector I received the folllowing error: Generic error BH1750. I tried another BH1750 sensor and I received the same error. I check the cable who seem to be good. I use a raspberry PI 3 B+ and the Anglo Hat rev 10.4. My Hydrosys software version is 3.27 B. I had the same problem with the version 3.24A. Any Idea ?
Pierre
Hello Angelo, I just found the problem in the last minutes. It was with one of my cable. Bad contact between the tip of the board I2C pin and the little crimpring female connector in the Dupont connector. Now my problem is solved . Thank for your support. Pierre
Hello,
Just tested it and had no issue with my Raspberry. I use the BH1750 gy-30.
I recall I had issues to connect the BH1750 gy-302 which is the smaller version but maybe it was just the particular sensor which had problems.