To test this feature, visit your live site.

Interrupt function empty

Hi Angelo, I did look on the forum but I could not find an answer.

If I go on the interrupt function, the systems says sensor not available. At the moment I have an hygrometer and a temp sensor connected to the hat V10. Am I doing something wrong? Do I have to connect any particular sensor to have this function available?

(p.s. same problem on the Fertilizer Plan, it says no actuators available).

Thank you!

Umbe

3 answers1 reply

4 Comments

Umbe

Jun 05, 2020

Hi Angelo all clear, thank you again for your help! Umbe

hydrosys4

Jun 05, 2020

Hi there,

yes, it is correct, first you have to create an interrupt associated with the PIN in the "hardwaresetting" page.

For the rain sensor connection, please refer to this post:

https://hydrosys4.wixsite.com/hydrosys4forum/forum/hardware-discussion/rain-sensor-connection-and-setup

Regarding the other point, you had the wrong expectation :).

The home page provides the 24 hours average of the sensor value, you can also see the min and max in the 24 hours in small font.

Ciao,

Angelo

hydrosys4

Jun 04, 2020

Hi Umbe,

First thing to do to setup the board is to load the hardware setting.

Go to "HardwareSetting" page and select a preset HW configuration. In your case you have the full board, you have to chose "Automation Hat v10 - hygro".

Then click "Apply selected hardware setting".

To see and test the hardware, you should go to the "Setting" page, you can test both the relay and the sensors.

For the Sensors, of course there are specific sensors working with the system which are listed in the "Hardware" page of the website: https://hydrosysblog.wordpress.com/hardware/

In this setting there are no interrupt or fertilizer activated by default, they can be activated according to the actual usage by changing the hardware table, that is the reason why it shown not present. To use the sensors you do not require the "interrupt" anyway.

In case you still have problems, you can send a picture of the connections, so I can have a look at it.

Regards,

Angelo

Umbe

Jun 05, 2020

Replying to

Hi Angelo,

I have set up everything as you suggested. For the interrupt page I will have to first activate the sensor in the hardware table to be able to set it up in the interrupt page, correct? How do I set it up? I am thinking ahead when I will try a rain sensor, once i get it from China :)

I have another question. I have noticed that the readings that I have at the moment (temperature and soil moisture) in the home page are wrong. Here a photo to make it more clear:

As you can see, it says temp 17.2 and moisture 45.5. This is not updates, if I go on the setting page and test them, they give me the following readings, which are correct:

The graphic page is correct and follows the last values. It seems that in the home page the update of the readings stopped early this morning..

Any idea why?

Thank you!