Hello - I would like to set up the system to turn an outlet (relay) on or off based on humidity readings from my BME280. How do I go about setting up the hardware page to do that? I would like the relay to turn on when humidity is below 50% and turn off once it reaches 60%. The relay is connected to GPIO17. I looked through all the reference and set up material but could not find how to program. Thanks for any hlep.
top of page
bottom of page
Hello,
The SW does not support activation with Hysteresis, It support normal activation over or below one threshold, like for example set the relay ON when humidity below 50%, and set the relay OFF when above 50%.
You can use the automation page. Here the link to a post with similar requirements:
If you still have doubts, please let me know.
Regards,
Angelo