i have installed a servo i tested the servo on hardware page does that 5 10 20 increments test
but under water plan it doesnt show up the servo.. so that it can open the water valve 45 degrees and then close 45 degrees as i find those Orbit water valves junk.. so i went with doing servos to open and close a valve
but how do i do that?
so i got it to show up in watering plan.. if i use a Relay and servo set for P1
the relay will come on but the Servo wont move.. what do i need to adjust
and i keep Reading System clock it actually wont sync properly.. if i sync my windows machine its right but when i READ Network time. its out by 30seconds
how do i get to sync right