Hi,

I have three valves which I need to run seperatly due to the water pressure.

I used one Schema P2 and defined to run at 8:00 for 10 minutes.

Then I assigned the P2 to all three valves.

First valve is using a 0 second delay.

Second valve is using a 600 second delay.

Third valve is using a 1200 second delay.

When there is exactly one rain drop, then this works flawlessly.

Valve 1 starts at 8:00 till 8:10

Valve 2 starts at 8:10 (basically it starts at 8:00 with 600 second delay)

Valve 3 starts at 8:20 (basically it starts at 8:00 with 1200 second delay)

So far so good.

Now I increased the rain drops from 1 to 3.

My assumption was, that also the dealy would increase, however that's not what I see.

Valve 1 starts at 8:00 till 8:30 (3 raindrops means 10 minutes runtime multiplied with 3).

Valve 2 starts still at 8:10 and runs till 8:40.

Valve 3 starts at 8:20 and runs till 8:50.

So between 8:10 and 8:40 too many valves are opened.

Apparently the delay I entered is not multiplied by the rain drops - is this how it is ment to work ?

I really liked the approach of the raindrops, since it accommodates for the increased water requirement in the summer months - but how should this be set up ?

Thanks a lot for any help!